Applicable for all (laboratory) worts
The Congress wort is heated in order to inactivate the amylolytic enzymes. Afterwards, 16 g/100 ml yeast is added, and the wort is allowed to completely ferment out in approx. 7 h.
Water intended for use as an ingredient in the production of beer (brewing liquor) or other foods
A specified quantity of water is evaporated, and any remaining moisture is subsequently eliminated in a drying oven. The dry residue is then weighed.
The method provides an estimate of the portion of pre-germinated barley grains at the time of harvest or prior to storage in silos.
Barley intended for the production of malt is evaluated with regard to pre-germination.
The onset of germination is accompanied by the synthesis of enzymes, which can be made visible using fluorescein dibutyrate (FDB). The reagent fluoresces in the presence of lipases.
In order to make the enzyme activity visible, the kernels are first split in half and coated with the FDB reagent after which they are examined in a suitable measuring device under UV light. An intense yellow fluorescence can be seen in the parts of the kernels where enzyme activity is present.
This method describes how to determine the extract content of malt used to produce laboratory wort.
Malt intended for use in beer brewing or elsewhere in the food industry
The extract content of malt refers to the compounds from finely ground malt (fine grind), which are brought into solution during a standardized mashing process.
The extract content is determined by the weight ratio sL 20/20 of the wort on the basis of the official sugar tables (Plato tables) at 20 °C. sL 20/20 stands for the weight ratio of a volume of wort at 20 °C to the same volume of water at the same temperature.
Malt intended for use in beer brewing or elsewhere in the food industry
Malt intended for use in beer brewing or elsewhere in the food industry
Viscometric Determination of Gelatinization Temperature (GT)
The gelatinization temperature (GT) can be determined using a rotary viscometer (e.g., amylograph or viscograph, Brabender GmbH & Co. KG, Germany [7] or Rapid-Visco-Analyser (RVA), Perten Instruments, a PerkinElmer Company, USA [8]).
Unlike the analysis method for adjuncts which do not contain a large amount of enzymes, for the analysis of barley malt, a mash with a mash to sparge ratio of 1 : 4 (similar to that commonly found in the brewing process) is used [9]. The sample is heated according to a programmable temperature/time program (refer to table 1) and the viscosity is measured using measuring stirrer throughout the process.
A gelatinization begins to occur, an increase in viscosity is registered; temperature of the sample is measured and identified as the corresponding gelatinization temperature. An increase in viscosity of a minimum of 24 cP (mPa × s) within six seconds is the evaluation criterion for the pasting temperature.