This method describes how to mill grain or malt to produce fine or coarse grist.
Malt intended for use in beer brewing or elsewhere in the food industry
Malt is ground between two horizontally positioned, grooved discs. The lower disc is driven by an electric motor and rotates at approx. 1500 rpm; the upper disc is fixed and therefore does not move. During the milling process, the malt migrates from the center of the discs to the outer edge, where the grist falls through an outlet spout into a grist beaker.
The gap between the discs can be adjusted by turning a socket head screw on a calibrated ring bearing scale markings. The scale on the calibrated ring ranges from 0 to 20, with each scale division corresponding to a gap between the discs of 0.10 mm. Each scale division is subdivided into five smaller divisions; each of the smaller marks is equivalent to 0.02 mm. Two gap adjusting rings ensure reproducible mill settings.
This method describes how to determine whether a lot of grain is contaminated with ergot visually through manual inspection.
Barley intended for the production of malt; therefore, the kernels are to be evaluated on the basis of the characteristics described below.
A representative sample of grain is visually inspected for the presence of ergot sclerotia.
Malt intended for use in beer brewing or elsewhere in the food industry
Viscometric Determination of Gelatinization Temperature (GT)
The gelatinization temperature (GT) can be determined using a rotary viscometer (e.g., amylograph or viscograph, Brabender GmbH & Co. KG, Germany [7] or Rapid-Visco-Analyser (RVA), Perten Instruments, a PerkinElmer Company, USA [8]).
Unlike the analysis method for adjuncts which do not contain a large amount of enzymes, for the analysis of barley malt, a mash with a mash to sparge ratio of 1 : 4 (similar to that commonly found in the brewing process) is used [9]. The sample is heated according to a programmable temperature/time program (refer to table 1) and the viscosity is measured using measuring stirrer throughout the process.
A gelatinization begins to occur, an increase in viscosity is registered; temperature of the sample is measured and identified as the corresponding gelatinization temperature. An increase in viscosity of a minimum of 24 cP (mPa × s) within six seconds is the evaluation criterion for the pasting temperature.