This method describes how to determine the sulfate content in water by cation exchange.
A water sample is run through an ion exchanger in which all of the cations are replaced with hydrogen ions. The sulfate is determined through titration in the presence of a previously prepared barium chloride solution, of which a known amount in excess of that required is added in advance. The quantity is measured by complexometric titration. The difference between the initial concentration of barium chloride and the amount determined by back titration corresponds to the sulfate content.
In many cases, particularly at higher contents, an alternative and sufficiently accurate measurement is possible, called the “negative m value” or the “total mineral acid value” (without carbonic acid). This is achieved through titration. Subsequently, the mval values for the anions (Cl-, NO3-, NO2-, PO43-) are subtracted from the result.
The cations in beer and wort are determined with this analysis.
This method is suitable for both wort and beer.
Inductively coupled plasma optical emission spectroscopy (ICP-OES) is a fast and reliable method for the laboratory analysis of metals. Inductively coupled plasma (ICP), a high frequency field of ionized gas, serves as a medium for atomizing and exciting the substances found in samples. Liquid, dissolved or aerosol samples are injected into the ionized gas stream. In emission spectroscopy, ICP can be used in conjunction with a number of optical and electronic systems either simultaneously or sequentially in multi-element spectrometers. In the plasma, the atoms and ions are excited to a higher energy state bringing about the emission of electromagnetic radiation (light), primarily in the ultraviolet and visible region of the spectrum. Metals ordinarily occur as ions in the temperature range typical for ICP of 6000 to 10000 K; however, non-metals and metalloids are only partially ionized.
ICP-OES operates within a very wide range. This usually encompasses six orders of magnitude in concentrations smaller than μg/l up to g/l, depending upon the element and the concentrations used for the set of analysis data. With ICP-OES, beer and wort can also be analyzed without prior processing of the samples, in contrast to AAS. Methods for determining the following in beer and wort will be described below: Al, B, Ba, Ca, Co, Cu, Fe, K, Mg, Mn, Mo, Na, P, Si, Sr, Sn and Zn.