The compounds in the malt dissolved in the mash liquor during a standardized mashing process using finely ground malt (fine grist) are determined in this analysis.
Malt intended for use in beer brewing or elsewhere in the food industry
The Congress mash method primarily serves to determine the extract content of malt.
The extract content is determined by the weight ratio sL 20/20 of the wort on the basis of the official sugar tables (Plato tables) at 20 °C. sL 20/20 stands for the weight ratio of a volume of wort at 20 °C to the same volume of water at the same temperature.
Furthermore, the following is tested over the course of this analysis: Iodine test (saccharification time), odor of the mash, wort run-off, clarity of the filtered wort; the Congress wort is also used as a basis for a wide variety of further analyses.
Wheat malt intended for use in the production of beer
This method describes how to conduct a simple descriptive test.
beer, beer-based beverages, non-alcoholic beverages, mineral water
This simple descriptive analysis provides a method for articulately communicating sensory attributes. The method can be utilized to formulate a list of attributes for the profile test. The list of attributes must then be statistically corroborated and reference samples employed to ensure that all of the testers identify the same reference substance for each of the given attributes (e.g., rancid butter, sweaty = reference substance butyric acid).
The moisture content of adjuncts is determined through the loss in mass during a standardized drying process, in which ground malt is dried at a defined temperature within a specified time in an electrically heated drying oven.
The moisture content is determined through the difference in the weight of the adjuncts prior to and after drying.
For samples with a moisture content greater than 17 % (for corn over 15 %), the sample has to be dried prior to conducting the analysis.
Prediction of the extract content and predetermination of the processability and value of a lot of barley for brewing purposes
The behavior of barley during the malting process, which is intended for large-scale malt production, must be known.
MEBAK approved and adopted a micromalting procedure on 6 April 1971 as a standard method for predicting the extract content and for determining the suitability of barley varieties for malting. In 2003, MEBAK shortened the procedure by one day for a total of six days for vegetative growth (steeping and germination), the same length of time as the EBC procedure.
Hops and hop products intended for use in beer brewing or elsewhere in the food industry
After milling, hops and hop powder products are extracted using a diethyl ether/methanol mixture and a hydrochloric acid solution. The α-acids and β-acids dissolved in the ether phase are separated using reversed phase high-pressure liquid chromatography (RP-HPLC) and measured spectrophotometrically at a wavelength of 314 nm.
Hop extracts are dissolved in methanol. The α-acids and β-acids dissolved in the methanol are separated using reversed phase high pressure liquid chromatography (RP-HPLC) and measured spectrophotometrically at a wavelength of 314 nm.